In part two I am installing a the conduit, sockets and lights to a new Pre-fab garage.

If you haven't seen part 1 already you can find it here.

What did it involve?

Using white plastic conduit, I installed metal clad sockets, switches and light fittings. Wired in twin and earth for this job.

Everything turned out great and I was really really happy with the outcome, plus the customer left me a cracking review!

In this video I am installing a new Power supply to a new Pre-fab garage. Part two will be the sockets, conduit and lighting installation!

What did it involve?

We installed a new power supply from an existing fuse board, clipped externally using some super linian fire clips.

We added a new fuse-board ready for part two of the installation.

As usual, we used our go-to Hager fuse-board, this was another job I absolutely loved, and I was very happy with the outcome. My client even boarded the garage for me!

A full install of garage electrics.

Quite a bit going on with this one, and tried to keep the video as short as possible.

The existing supply was already in the garage, which was supplied by a metal conduit and single insulated cables. I pre-tested this and checked the bonding on a visit a couple of days before just so that I knew all was ok.

The conduit for the new consumer unit was a little tricky to get right, but once that was in we were ready for the main install.